XYZ Printing da Vinci Jr.1.0w User Manual page 14

CALIBRATE
To ensure printing quality, please update printer firmware to the latest version. With latest printer
firmware, you may calibrate the print bed in case of low quality printing.
1. Active print bed calibration by selecting "UTILITIES">"CALIBRATE">"YES" on the screen.
2. Press the detection head on the right side of the print head according to the instruction of screen message,
followed by pressing OK.
PRESS DETECTOR
NEXT TO EXTRUDER
[OK] TO CONTINUE
3. Wait for detecting.
4-1A. If "SUCCESS" is shown for the detection
result, and "AUTO LEVEL OFF" is shown on the
third row on the screen, it indicates good platform
levelness. Press "OK" to exit and print.
CALIBRATE
SUCCESS
AUTO LEVEL OFF
[OK] TO RETURN
4-2. If the detecting result is shown as "FAIL",
press "OK" to go to next page, and press "OK"
again to exit.
CALIBRATE
FAIL
AUTO LEVEL ON
[OK] TO CONTINUE
Note:
1.The dirt on the detection head and the top of print module will influence detection result. Make sure that
the dirt is cleaned before calibration the platform, and remember to install and locate the print module.
2. If the residues is on the top of the print module, the detection result will be shown as follows. Clean
the dirt before recalibration of the platform. Clean the dirt before recalibration of the platform.
A 0000 0000 0000
B 0000 0000 0000
C 0000 0000 0000
[OK] TO RETURN
3. The printer may enable or disable auto-level based on the result of calibration. You may switch off
the function manually under "Settings".
PLEASE CONTACT
CUSTOMER SERVICE
[OK] TO RETURN
UTILITIES
4-1B. If you see "AUTO LEVEL ON" under "SUCCESS",
this indicates that the print bed is slightly unleveled.
The printer will adjust the configuration based on the
detecting result automatically while "AUTO LEVEL" is
enabled. The printing mode helps to improve printing
quality with slower printing speed. You may switch off
the function under "Settings".
CALIBRATE
SUCCESS
AUTO LEVEL ON
[OK] TO RETURN
And check the detecting result by going to "INFO">
"LEVELING INFO". Contact customer service for the
issue and provide the details of leveling information.
A 0317 0320 0313
B 0318 0323 0308
C 0312 0300 0440
[OK] TO RETURN
da Vinci Jr.1.0
2016
Ver. 1.8 April
P 14