Lamp Replacement - Christie L2K1500 Setup Manual

Lamp Replacement

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and
LAMP REPLACE indicator lights orange. Replace the lamp with a new one after it has cooled down. The timing when the
LAMP REPLACE indicator lights up is depending on the mode that you specified for the Lamp control function.
LAMP REPLACE indicator
LAMP REPLACE indicator
LAMP 1/2/3/4 REPLACE indicators
Follow these steps to replace the lamp.
1
Check the LAMP 1/2/3/4 REPLACE indicators on top of
the projector. When any of the indicators blinks rapidly,
wait at least 20 minutes until it blinks slowly. After
that, go to the next step. When any of the indicators
blinks slowly, go to the next step.
2
Loosen the screw on the lamp cover. Open the lamp
cover. (See the right upper figure.)
3 Loosen the two screws that securing the lamp and
pull out the lamp by using the handle. (See the right
lower figure.)
4
Replace the lamp with a new one and tighten the
two screws. Make sure the lamp is set properly.
5
Close the lamp cover and tighten the screw.
CAUTION
Allow the projector to cool for at least 20 minutes
before you open the lamp cover. The temperature
inside the projector becomes very hot.
CAUTION
When replacing the lamp because it has stopped
illuminating, there is a possibility that the lamp may be
broken. If replacing a lamp of the projector which has been
installed on the ceiling, you should always assume that
the lamp is broken, and you should stand to the side of
the lamp cover, not underneath it. Remove the lamp cover
gently. Small pieces of glass may fall out when the lamp
cover is opened. If pieces of glass get into your eyes or
mouth, seek medical advice immediately.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER.
020-000410-01 Rev.1 (05-2011)
Lamp replacement icon
- 19 -
LAMP 4
LAMP 3
SCREW
CAUTION
- For continued safety, replace with a lamp assembly
of the same type.
- Do not drop the lamp assembly or touch a glass
bulb! The glass can shatter and may cause injury.
- When replacing the lamp, do it within 30 minutes
after opening the lamp cover.
- Do not insert hand in the empty lamp compartment
after the lamp is removed.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your
dealer. When ordering a Projection Lamp, give the
following information to the dealer.
Model No. of your projector
●
L2K1500
Replacement Lamp Type No.
●
003-120599-01
LAMP COVER
SCREW
LAMP 2
SCREW
HANDLE
LAMP 1
(Service Parts No. 610 350 9051)