Safety Precaution; Federal Communications Commission Notice - Christie L2K1500 Setup Manual

Before installing and operating the projector, read this
manual thoroughly. Improper operation may result in not
only shortening the product life, but also malfunctions, fire
hazard, or other accidents.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO R E D U C E T H E R I S K O F E L E C T R I C
SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
INSIDE EXCEPT LAMP REPLACEMENT.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
THIS SYMBOL INDICATES THAT DANGEROUS
VOLTAGE CONSTITUTING A RISK OF ELECTRIC
SHOCK IS PRESENT WITHIN THIS UNIT.
TH IS SYM BOL IN D I C AT ES T H AT T H ER E A R E
IMPORTANT OPERATING AND MAINTENANCE
INSTRUCTIONS IN THIS MANUAL WITH THIS UNIT.
FOR EU USERS
The symbol mark and recycling systems described below
apply to EU countries and do not apply to countries in other
areas of the world.
Your product is designed and manufactured with high quality
materials and components which can be recycled and/or
reused.
The symbol mark means that electrical and electronic
equipment, batteries and accumulators, at their end-of-
life, should be disposed of separately from your household
waste.
Note:
If a chemical symbol is printed beneath the symbol mark,
this chemical symbol means that the battery or accumulator
contains a heavy metal at a certain concentration. This will be
indicated as follows: Hg: mercury, Cd: cadmium, Pb: lead
In the European Union there are separate collection systems
for used electrical and electronic equipment,
batteries and accumulators.
Please, dispose of them correctly at your local
community waste collection/recycling centre.
Please, help us to conserve the environment
we live in!

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Do not make any changes or modifications to the equipment unless otherwise specified in the instructions.
If such changes or modifications should be made, you could be required to stop operation of the
equipment.
Canadian Radio Interference Regulations
This Class A digital apparatus meets all requirements of the Canadian ICES-003.
WARNING
This is a Class A product. This product may cause radio interference in residential areas, in which, the
user may be required to take adequate measures.

Safety Precaution

– This projector produces intense light from the projection lens. Do
not stare directly into the lens, otherwise eye damage could result.
Be especially careful that children do not stare directly into the
beam.
– Install the projector in a proper position. Otherwise it may result in
a fire hazard.
– Allowing the proper amount of space on the top, sides, and rear of
the projector cabinet is critical for proper air circulation and cooling
of the unit. The diagrams shown here indicates the minimum
space required. If the projector is to be built into a compartment or
similarly enclosed, these minimum distances must be maintained.
SIDE and TOP
3.3' (1m)
3.3' (1m)
– Do not cover the ventilation slots on the projector. Heat build-
up can reduce the service life of your projector, and can also be
dangerous.
– If the projector is unused for an extended time, unplug the
projector from the power outlet.
– Do not project the same image for a long time. It may be burned
into the LCD panels.
CAUTION ON HANGING FROM THE CEILING
When hanging the projector from the
ceiling, clean the air intake vent and top
of the projector periodically with a vacuum
cleaner. If you leave the projector unclean
for a long time, the cooling fans can be
clogged with dust, and it may cause a
breakdown or a disaster.
DO NOT SET THE PROjECTOR IN GREASy, WET,
OR SMOKy CONDITIONS SUCH AS IN A KITCHEN
TO PREVENT A BREAKDOWN OR DISASTER. IF THE
PROjECTOR COMES IN CONTACT WITH OIL OR
CHEMICALS, IT MAy BECOME DETERIORATED.
- 2 -
REAR
3.3' (1m)
020-000410-01 Rev.1 (05-2011)