Lamp Replacement - Christie DHD800 Setup Manual

Lamp Replacement

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the
screen and LAMP 1/2 REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing
when the LAMP 1/2 REPLACE indicator should light is depending on the lamp mode.
Indicators
Lamp replacement icon
LAMP 1 / 2 REPLACE indicators
Follow these steps to replace the lamp.
Check the number of lamp to be replaced on the Lamp Status
1
Display.
Turn off the projector, press the Main On/Off Switch to Off and
2
unplug the AC power cord from the AC outlet. Let the projector
cool for at least 45 minutes.
Loosen a screw on the Lamp Cover. Slide and open the Lamp
3
Cover. (See the right figure.)
Loosen two screws and pull out the Lamp to be replaced by
4
grasping handle.
Replace the Lamp with a new one and tighten two screws.
5
Make sure the Lamp is set properly.
Put the Lamp Cover back and tighten a screw.
6
CAUTION : DO NOT OPERATE THE PROJECTOR WHILE ANY OF LAMPS IS REMOVED. IT MAY RESULT IN
MALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTS.
NOTES ON LAMP REPLACEMENT
To maintain quality of picture (better balance of color and brightness in entire screen), we recommend
replacing both 2 lamps at a time.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following
information to the dealer.
●
Model No. of your projector
DHD800
●
Replacement Lamp Type No.
003-120577-01
CAUTION
Allow the projector to cool, for at least 45 minutes
before you open Lamp Cover. The inside of the
projector can become very hot.
(Service Parts No. 610 350 6814)
- 19 -
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER.
SCREW
LAMP
COVER
SCREWS
Make sure which number of lamp needs to be
replaced on Lamp Status Display.
Figure shows case of replacing LAMP 2.
CAUTION
For continued safety, replace with a lamp
assembly of the same type.
Do not drop the lamp assembly or touch a glass
bulb! The glass can shatter and may cause injury.
020-000247-02 Rev. 1 (01-2012)
LAMP 1
LAMP 2
DHD800 Setup Guide