Lamp Replacement - Christie LX505 Quick Reference Manualninja250L

Lamp Replacement

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears
on the screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one
promptly. The timing when the LAMP REPLACE indicator should light is depending on the lamp mode.
Follow these steps to replace the lamp.
1
Turn off the projector and unplug the AC
power cord. Let the projector cool for at least
45 minutes.
2
Loosen the screw and open the lamp cover.
Loosen 3 screws of the lamp and pull out the
lamp by using the built in handle.
Replace the lamp with a new one. Make sure
3
that the lamp is properly and fully inserted.
4
Close the lamp cover and secure the screw.
Connect the AC power cord to the projector
5
and turn on the projector.
Note:
Be sure to insert the lamp in the correct direction.
CAUTION
When replacing the lamp because it has stopped
illuminating, there is a possibility that the lamp
may be broken.
If replacing the lamp of a projector which has
been installed on the ceiling, you should always
assume that the lamp is broken, and you
should stand to the side of the lamp cover, not
underneath it. Remove the lamp cover gently.
Small pieces of glass may fall out when the lamp
cover is opened.
If pieces of glass get into your eyes or mouth,
seek medical advice immediately.
CAUTION
Allow a projector to cool for at least 45 minutes
before you open the lamp cover. The inside of
the projector can become very hot.
LX505/605
Downloaded From projector-manual.com Christie Manuals
Lamp cover
Lamp
New
Lamp
CAUTION
For continued safety, replace with a
lamp of the same type. Do not drop
the lamp or touch the glass bulb! The
glass can shatter and may cause
injury.
Setup Guide
18
020-000540-01 Rev. 1 (11-2010)
Handle