Seagull Models Savage Cruiser Assembly Manual page 22

SAVAGE CRUISER
4) When you are sure that everything is
aligned correctly, mix up a generous
amount of Flash 30 Minute Epoxy. Ap-
ply a thin layer to the mounting slot
and to bottom of the vertical stabilizer
mounting area. Apply epoxy to the bot-
tom and top edges of the filler block and
to the lower hinge also. Set the stabilizer
in place and realign. Double check all of
your measurements once more before the
epoxy cures. Hold the stabilizer in place
with T-pins or masking tape and remove
any excess epoxy using a paper towel and
rubbing alcohol. Allow the epoxy to fully
cure before proceeding.
ELEVATOR AND RUDDER PUSHROD
HORN INSTALLATION.
Rudder control horn.
22 22
Epoxy.
Elevator control horn
Instruction Manual.
Elevator control horn.
Rudder control horn.
M2 clevis.
600mm
Crimp.
Cable end
M2 clevis.
Hex nut.
M3 clevis.
Fuel Tubing.
M3 clevis.
M2 lock nut
Metal connector
M3 clevis.
Fuel Tubing.
M2 clevis.
Hex nut.