Seagull Models Savage Cruiser Assembly Manual page 20

SAVAGE CRUISER
INSTALLING THE FLAP SERVO.
Repeat the procedure for the aileron servo.
M3 clevis.
M3 clevis.
Hex Nut.
INSTALLING THE HORIZONTAL STABILIZER.
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at
the trailing edge, and place a mark. Use
a triangle extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.
2) Using a modeling knife, carefully
remove the covering at mounting slot of
horizontal stabilizer (both side of fuse-
lage).
20 20
80mm
M3 lock nut.
Fuel Tubing.
Instruction Manual.
3) Slide the stabilizer into place in the
precut slot in the rear of the fuselage. The
stabilizer should be pushed firmly against
the front of the slot.
4) With the stabilizer held firmly in place,
use a pen and draw lines onto the stabilizer
where it and the fuselage sides meet. Do this
on both the right and left sides and top and
bottom of the stabilizer.
5) Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove
the covering from between them using a
modeling knife.
Cut.
Pen.
Trim and Cut