Operation
3. Remove the new cartridge from its cellophane packaging.
4. Pull out, remove, and dispose of the spring clamp located on the right side of
the new cartridge. See Figure 3-5.
5. Turn the red knob on the top of the cartridge clockwise to tighten the ribbon
tension.
6. Fit the ribbon over the front of the printhead and insert the cartridge into the
same place where the old cartridge was. It should easily snap into place. Adjust
the ribbon tension, ifnecessary, by turning the red tension knob on the top of
the cartridge clockwise.
RIBBON
SPRING CLIP
Figure3-5. Ribbon Cartridge
3-9
CY93-01