Packing The Unit; Host-Printer Connection - Honeywell PRU7070 Handbook

I
8. Place the printer where you desire to use it.
9. Remove the data cable from the pouch in which it was shipped. SA VE the
pouch for future use.
10. Connect the data cable to the printer. This procedure is explained later in this
section. Figure 3-1 shows the receptacle for the data cable.
WARNING
You must follow the Data Cable Connecting procedure carefully to
ensure that a correct connection is made. An incorrect connection
could damage the equipment.
11. PI ug in the Power Cord. See Figure 3-1. The printer is now ready for use.
Packing the Unit
1. Disconnect the Data Cable and the Power Cord.
2. Open the printer cover and remove the ribbon cartridge.
3. Pack the ribbon cartridge in a clean envelope or some other protective device.
4. Take the protective material that you have saved and pack this material care-
fully around the internal mechanics.
Note: Ensure that the printhead is tied down and not capable of any move-
ment.
5. Close and secure the cover to the base of the printer by using either a piece of
masking tape or a strong elastic.
6. Carefully place the printer into the box in which it was shipped.
7. Put the data cable into the pouch in which it came.
8. Put the data cable and pouch into the printer box.
9. Seal the box with tape. The printer is ready for shipment.
Host-Printer Connection
The host-printer connection may be either direct connect or via a modem interface.
Figure B-1 shows these connections.
Maintenance, Shipping, and
Installation Procedures B-2 CY93-01