Section 3. Operation; Power On And Startup Procedure - Honeywell PRU7070 Handbook

Section
3
Operation
This section describes the procedures necessary to operate the printers. Honeywell
recommends that anyone using the printers first read through all of the steps
before
performing any procedure.
Power On and Startup Procedure
Operation
1. Check to see that the power cord is plugged into the ac wall outlet. See Figure 3-1.
2. Check to see that the data cable is connected properly to the printer. Figure 3-1
shows the receptacle for the data cable. If the data cable is not connected to the
. printer, follow the connecting procedures in Appendix B.
I I I I I I I I I I I I I II I
I
I
Figure3-l. PowerCordandDataCableReceptacle
3-1 CY93-01
I