Table of Contents
Advertisement
When the printer is online, the ONLINE indicator will be lit, and the printer is
able to receive data from the directly connected controller or adaptor.
When the printer is offline, the ONLINE indicator will not be lit, no data can be
received from the controller or adaptor, paper can be loaded, and a local form feed
can be performed.
The Print-Test procedure explained in Section 3 must be initiated immediately
after powering on by pressing the ON LINE switch.
FORM FEED
This switch allows you to perform a FORM FEED procedure when the ON LINE
indicator is not lit. The FORM FEED procedure advances the paper to the begin-
ning of the next form if the paper has been properly aligned using the Paper Move-
ment Knob, Figure 2-3. This procedure has no effect if the ONLINE indicator is lit.
Operation Panel Indicator Lights
ONLINE
When this indicator is lit, the printer is available to receive print data imme-
diately from the controller.
Note: The FORM FEED and PRINT-TEST procedures cannot be performed
when this indicator is lit.
When this indicator blinks, either a fault has occurred or the printer is out of
paper. See the SELF -CHECKING procedure in Section 3 to handle this problem.
When the ON LINE indicator is not lit, the printer cannot receive messages from
the controller.
POWER ON
When this indicator is lit, the printer is ON. The POWER ON/OFF switch must be
turned ON before this indicator will light.
Controls and Indicators
2-3
CY93-01
Advertisement
Table of Contents
