Ptz Setup - COP Security inspire black 960h User Manual

PTZ setup

There are four steps to setting up a PTZ camera, options 2, 3 & 4 can only be set after
option 1 (PTZ Protocol) has been set.
Settings for PTZ preset positions is optional but options 1,2 & 3 must be set and they must
match the settings on the PTZ camera.
1: Select Protocol
This is the language that the DVR will use to communicate with the PTZ camera.
Options
• Pelco P
• Pelco D
2: Set Baud rate
This is the transmission speed used to communicate with the PTZ camera. It is
recommended that a slow speed is used as this will increase the reliability of the
communication.
Options
• 1200 baud
• 2400 baud (default)
• 4800 baud
• 9600 baud
3: PTZ ID
Each PTZ camera must have a separate ID this is set in both the PTZ camera and the
DVR. e.g. If PTZ on channel 1 is set to ID1, set to ID1 in DVR menu, if PTZ is set to ID2, ID3
etc, then set to corresponding ID in DVR menu.
Options
• 1 to 255
4: PTZ Preset Setup
You can use the DVR to set preset positions on the PTZ camera. It is not necessary to use
the DVR if a joystick controller is used with the PTZ camera as setting preset positions can
be set much easier using the joystick keyboard.
Also only preset positions 1 to 16 can be set using the DVR but when using a joystick
keyboard many more preset positions can be programmed, if the PTZ camera used will
support them.
Options
• Set Preset 1 to 16
Engineer Manual
Inspire Black 960H DVR Range
71