KTM 2011 690 SMC EU Repair Manual page 106

16 ENGINE
–
Attach the spark plug connector.
–
Plug in the connector of the engine coolant temperature sensor
300219-11
–
Reconnect plug-in connections
tion sensor, and the alternator.
300218-11
–
Slide the throttle valve body into the rubber sleeves.
–
Position and tighten hose clip
300217-11
–
Position the electrical connection
screw.
Guideline
Screw, cable on starter motor
–
Position the ground wire on the starter motor. Mount and tighten screw
Guideline
Screw, starter motor
300216-11
–
Insert the clutch push rod.
–
Position the clutch slave cylinder.
–
Mount and tighten screws
Guideline
Screw, clutch slave cylin-
der
Screw, clutch slave cylin-
der
300214-11
–
Mount the engine sprocket with the chain.
–
Position the new lock washer and mount nut
–
Position the rear wheel.
–
Mount the chain adjuster and nut.
–
Push the rear wheel forward so that the chain adjusters are on the tensioning
screws, and tighten the nut
Guideline
Nut, rear wheel spindle
300215-11
of the gear position sensor, the crankshaft posi-
7
.
8
on the starter motor. Mount and tighten the
9
M5
M6 10 Nm
(7.4 lbf ft)
.
bl
M6x20 10 Nm
(7.4 lbf ft)
M6x35 10 Nm
(7.4 lbf ft)
but do not tighten yet.
bm
.
bn
M25x1.5
104
.
6
3 Nm (2.2 lbf ft)
.
bk
Loctite ® 243™
Loctite ® 243™
–
90 Nm
(66.4 lbf ft)