Installing Alternator Cover; Installing Starter Motor - KTM 2011 690 SMC EU Repair Manual

16 ENGINE

16.5.32 Installing alternator cover

16.5.33 Installing starter motor

–
Position the oil screen
–
Mount and tighten screw plug
Guideline
Plug, oil screen
300161-11
–
Apply sealing compound lightly in the area of the cable sleeve.
–
Install the dowel
300005-10
–
Position the alternator cover.
–
Mount and tighten screws
Guideline
Screw in alternator cover
–
Mount and tighten screw
Guideline
Screw, alternator cover
(chain shaft through-hole)
300004-11
–
Remove special tool
Engine blocking screw (77329010000) (
–
Mount and tighten screw
Guideline
Screw plug, crankshaft clamp
300024-11
–
Grease O-ring. Mount the starter motor.
Long-life grease (
–
Mount and tighten screws
Guideline
Screw, starter motor
300001-01
with O-rings.
3
with the O-ring.
4
M20x1.5
. Put on the alternator cover seal.
1
.
2
M6
.
3
M6
.
4
.
5
M8
p. 208)
.
1
M6
15 Nm
(11.1 lbf ft)
10 Nm (7.4 lbf ft)
Loctite 243™
10 Nm ®
(7.4 lbf ft)
p. 218)
20 Nm
(14.8 lbf ft)
10 Nm Loctite ® 243™
(7.4 lbf ft)
158