NETGEAR GS700TP Software Administration Manual page 37

GS700TP Smart Switch Software Administration Manual
• Idle Timeout – Enter the amount of time (minutes) that elapses before an idle station is
timed out. Idle stations that are timed out must login to the system. The field range is 5 -
30 minutes. The field default value is 10 minutes.
• Base MAC Address – Displays the MAC Address.
• Serial Number – Displays the device serial number.
• Jumbo Frames Status – Displays the Jumbo Frame status.
• Jumbo Frames After Reset – Select the Jumbo Frame status. The possible field values
are:
– Enable – Enables Jumbo Frames.
– Disable – Disables Jumbo Frames. This is the default value.
The Versions Table displays the following fields:
• Model Name – Displays the device model name.
• Hardware Version – Displays the installed device hardware version number.
• Boot Version – Displays the current boot version running on the device.
• Software Version – Displays the installed software version number.
2. Enter the System Name, System Location, System Contact and Idle Timeout in the
provided fields.
3. Select whether to enable or disable Jumbo Frames After Reset.
4. Click APPLY to update the system settings.
IP Configuration
The IP Configuration screen contains fields for assigning IP addresses. IP addresses are either
defined as static or are retrieved using the Dynamic Host Configuration Protocol (DHCP). The
DHCP assigns dynamic IP addresses to devices on a network. DHCP ensures that network devices
can have a different IP address every time the device connects to the network.
Note the following when configuring IP Addresses:
• If the device is accessed using SmartWizard Discovery, the IP address retrieved through
DHCP is displayed.
• If the device fails to retrieve an IP address through DHCP, the default IP address is
192.168.0.239.
3-3
v1.0, November 2009
Managing System Settings