NETGEAR GS700TP Software Administration Manual page 17

GS700TP Smart Switch Software Administration Manual
4. Start the SmartWizard Discovery utility.
5. Click Discover for the SmartWizard Discovery utility to find your GS700TP Gigabit PoE
Smart Switch. You should see a screen similar to that shown in Figure 1-2.
6. Click Configuration Setting. A screen similar to that shown below appears.
Figure 1-2
7. Select Disable to disable DHCP.
8. The default IP address is 192.168.0.239 and the default subnet mask is 255.255.255.0. If you
want different values, enter the switch IP address, gateway IP address and subnet mask.
9. Type your password and click Set. Please ensure that your PC and the GS700TP Gigabit PoE
Smart Switch are in the same subnet. Note the settings for later use.
1-5 Getting Started with Switch Management
v1.0, November 2009