Install the back cover as described below.
・
<Installing the back cover>
Align 8 tabs of the back cover with concaves of FOMA terminal.
While pressing the back cover in the direction of a so that there is
no gap between FOMA terminal and back cover, slide the back cover
in the direction of b to install, then slide the back cover lever in the
direction of c to lock.
Back cover
* Make sure that the back cover is completely closed without slack. Slide the
back cover in the direction of the arrow shown on the lever, and then make
sure the cover is securely locked before using.
Securely lock the back cover and firmly close the external connection
・
jack cap. Even a fine obstacle (one hair, one grain of sand, tiny fiber,
etc.) put between contact surfaces may allow water to enter.
Do not poke the microphone, earpiece or speaker with a swab or
・
sharp object.
Do not let FOMA terminal fall. It may become scratched causing the
・
waterproof performance to degrade.
b
a
Lever
The external connection jack cap and the rubber packing of the inner
・
lid play an important role for keeping waterproof performance. Do
not remove or scratch it. Also, prevent dust from adhering to it.
To keep the FOMA terminal waterproof, replacement of parts is
required every 2 years regardless of whether FOMA terminal appears
normal or abnormal. DOCOMO replaces the parts as a chargeable
service. Bring FOMA terminal to a sales outlet such as a DOCOMO-
specified repair office.
Important precautions
Do not perform actions shown in the illustrations below.
<Example>
Using Soap/Detergent/
Applying strong water flow
Bath power
Soaking in ocean water
Observe the following precautions to use FOMA terminal properly.
・
Accessories and optional devices are not waterproof. When
watching 1Seg etc. with FOMA terminal installed in the included
desktop holder, do not use it in a bathroom, shower room, kitchen or
lavatory even if it is not connected to the AC adapter.
Using in hot spring
Soiling with sand/mud
17
Need help?
Do you have a question about the F-08B and is the answer not in the manual?