Setting Dialup Network - Docomo F-08B Instruction Manual

❖
Show/Hide caller ID function by dialup network settings
The dialup network settings can also be used to append 186 (Notify)/184 (Not notify) to the dialup
connection number.
･
The Show/Hide of caller ID when both of the ＊DGPIR command and dialup network settings are set is
as shown below.
Setting made by ＊DGPIR
Dialup network
setting (<cid>=3)
＊99＊＊＊3#
184＊99＊＊＊3#
186＊99＊＊＊3#

◆ Setting dialup network

A case of IP connection to mopera U by Packet communication is described as an example.
･
To connect to mopera U or mopera by packet communication, enter the followings in the phone number
field.
mopera U (PPP connection) : ＊99＊＊＊2＃
mopera U (IP connection) : ＊99＊＊＊3＃
128K communication (PPP connection) : ＊99＊＊＊4＃
mopera (PPP connection) : ＊99＊＊＊1＃
･
To connect mopera U or mopera by 64K data communication, enter the following phone numbers in the
phone number field.
mopera U : ＊8701
mopera : ＊9601
❖
Setting for Windows 7, Windows Vista
1
Click (Start)→"コントロールパネル (Control panel)"→"ネットワークの状態
とタスクの表示(Network status and tasks)" in "ネットワークとインターネット
(Network and Internet)" category.
Under Windows Vista
Click (Start)→"接続先 (Dialup connection)".
2
Click "新しい接続またはネットワークのセットアップ (Setup new connection
or network)".
Under Windows Vista
Click "接続またはネットワークをセットアップします (Set up connection or network)".
command No setting
Caller ID is sent
19
Caller ID is not sent Caller ID is sent
Caller ID is not sent
Caller ID is not sent
Caller ID is sent
Caller ID is sent