Installation - REMEHA Avanta Plus 35c Installation And Service Manual

2 INSTALLATION

LT.AL.W7H.000.011
4 0
0
m i
n .
2 5
6 7
0
m i
n .
2 5
0
3 0
0 0
n . 6
m i
LT.AL.W7H.000.003
2.1 Scope of delivery
The standard delivery of the Remeha Avanta Plus boiler
includes:
- the boiler (including pressure gauge and safety valve);
- mounting plate (including isolation valve set and washers);
- nylon plugs and screws for fixing mounting plate;
- copper tails 15/22 mm;
- mounting template;
- filling loop;
- Boiler Service Log Book;
- Installation and Service manual and Users guide.
This Installation and Service manual deals with the standard
supplied boiler only. For the installation or assembly of any
optional accessories supplied with the boiler, such as stand off
frame, pipework kits, cover plate, control kits, etc, please refer
to the Assembly Instructions supplied with these accessories.
2.2 Mounting the boiler
Packed in the box with the Remeha Avanta Plus box is this
Installation and Service manual. Read instructions and remarks
carefully. This section includes the guidelines and instructions
for the connection of gas, water, electricity, safety devices, the
regulator, control unit, flue discharge and air supply.
2.2.1 Clearance requirements
The gas and water connections are located on the bottom of
the boiler whilst the air in and flue gas outlet is located on the
top of the boiler. The boiler is supplied as standard with pipe-
work tails to allow connections facing downwards.
Optional stand off frame and pipework kits are available
to enable the pipework to run upwards behind the boiler if
required. For installation, servicing and inspection min. 600
mm in front of the boiler is required. If this free space is
obtained by opening a door or removing a panel, the boiler
may be installed for instance in a closed cupboard.
We do recommend a side clearance of 0.5 cm so that the unit
0
is easy to open, with a free space of 25 cm under the appli-
ance and 25 cm above the appliance, as the minimum require-
ment.
0
7