Changing The Maximum Output (Hi) For Ch Operation - REMEHA Avanta Plus 35c Installation And Service Manual

R
Changing the factory settings could result in the boiler not
working properly.
The parameters can be changed from the stand-by status as
follows:
• Press the [enter]-key and briefly the [reset]- key until
• Press the [+]-key until access code 12 is displayed.
• Press the [enter]-key until p1 appears (codes p [ and
• This parameter can now be changed as follows;
• Press the [enter]-key; the set value for the maximum flow
• Press the [+] or [-]-key to change this value, for example to
• Press [enter]-key to confirm the value; codes p [ and [
• Press the [+]-key to change the next parameter, etc.
• Press [reset]-key to return to the operating mode.
LT.AL.W7H.000.047
The boiler will automatically return to the normal operating
mode if no keys are pressed for 10 minutes.

2.9.9 Changing the maximum output (Hi) for CH operation

The maximum output for CH operation can be changed with
parameter p 17 (maximum fan speed) and is set standard
to a speed of 3700, 4100 or 5000 rpm. See the speed-input
R
ratio figures.
This parameter can be changed from the stand-by status as
follows:
• Press the [enter]-key and briefly the [reset]- key until
• Press the [+]-key until access code 12 is displayed.
• Press the [enter]-key until p1 appears (codes p [ and
• Press the [+]-key to go to parameter 17.
• Press the [enter]-key until p17 appears (codes p [
• Press the [+] or [-]-key to change this value for Avanta Plus
• Press [enter]-key to confirm the value.
• Press [reset]-key to return to the operating
LT.AL.W7H.000.048
38
Remeha Avanta Plus
codes c and 0 appear alternately in the display.
[ 1 are displayed alternately);
temperature now appears e.g.; 75 (75°C).
65 (65°C).
1 are displayed alternately.
codes c and 0 appear alternately in the display.
[ 1 are displayed alternately);
and 17 are displayed alternately);
28c, for example to 46 (4600 rpm corresponds with 22
kW).
mode.