NetComm NP2624M User Manual page 75

4.2.4.4. Maximum bridge transmit delay bound
1. Max bridge transmit delay bound: Limits the packets queuing time in switch. If
enabled, when the amount of time the packets queued exceeding the maximum they will
be dropped. Press the Space key to set the time. Those valid values are 1sec, 2sec, and
4sec and off. Default is off.
2. Low Queue Delay Bound: Limits the low priority packets queuing time in switch. If
enabled, when the amount of time the low priority packet stays in the switch exceeds
Low Queue Max Delay Time, it will be sent. Press the Space key to enable or disable
this function. Default is disable.
3. Low Queue Max Delay Time: To set the amount of time that low priority packets
queuing in switch will be delayed. The valid range is 1~255ms. Default Max Delay
Time is 255ms.
NOTE: Make sure "Max bridge transmit delay bound control" is enabled
before enabling Low Queue Delay Bound, because Low Queue
Delay Bound must be work under "Max bridge transmit delay bound
control" is enabled situation.
NP2624M User Guide
YML827 Rev1
75