NetComm NP2624M User Manual page 65

NOTE: Pressing "Save" will only save one page of configuration. If static
trunk groups exist, they will be displayed (eg: TRK1, TRK2...) after
port 26, and you can configure them as above.
4.2.2. Trunk Configuration
This page allows the user to create a maximum of seven trunk groups. Users can arbitrarily select
up to four ports from port 1~port 26 to build a trunk group.
1. Select <Edit> on the actions menu
2. Press space key to configure the member port of trunk group. You also have to set
"Static" or "LACP" for the corresponding trunk group of TRK1~TRK7 item.
"Static" – the normal trunk.
"LACP" – this trunk group has link aggregation control protocol.
3. Press Ctrl+A to go back action menu line
4. Select <Save> to save all configure value.
5. If the TRK1~TRK7 are "Disabled", the trunk group is deleted.
6. All ports in the same static trunk group will be treated as a single port. So when setting
VLAN members and Port configuration they will be toggled on or off simultaneously.
NOTE: If a VLAN group exists, all of the members of static trunk group must
be in the same VLAN group.
NP2624M User Guide
YML827 Rev1
65