Sears free spirit C 249 30427 1 Owner's Manual page 22

Care has been taken to assure that your treadmill has been properly adjusted and lubricated at the factory. It is
not recommended that the user attempt service on the internal components instead seek service from an
authorized service center. However, from time-to-time the outer surfaces may appear dull or dirty, following
the instructions listed below will restore and preserve the original finish.
Note: Always unplug your treadmill prior to cleaning in order to avoid electrical hazard or shock.
1. Cleaning metal surfaces may be accomplished by using a soft cotton or terry cloth rag with a light
application of car wax. Do not use aerosol sprays or pump bottles as they may deposit wax upon the
walking or computer surface.
2. Under no circumstances are you to use ammonia, oils, silicones or any other compounds on the rubberized
walking surface. The use of such materials may cause serious injury to the body and/or deteriorate the
performance of the walking surface. Only clean the rubberized walking surface with a damp cloth (water
only).
3. From time-to-time the computer surface may collect dust or finger prints. The use of harsh chemicals will
destroy the protective coating and cause a static build up that will damage the components. This surface
may be cleaned with specially prepared chemicals found in most computer supply stores especially made
for anti-static surfaces. It is strongly recommended that you purchase such a cleaning compound.
MAINTENANCE INSTRUCTIONS
CLEANING
21