Placing Calls - NEC XN120 Vision User Manual

If your call doesn' t go through...
Checking & Answering a Message Waiting Indication
You can check who left a message waiting indication for you, and then answer.
CHECK
8
(On-Hook)
u Applicable to XN120 Vision Telephones only.
Cancelling a Message Waiting Indication (at originating extension)
you want to cancel MW
CALL
8 7 1
Clearing All Message Waiting Indications (at any extension)
CALL
8 7 3
u Clears all messages you have left for other extensions and messages other extension have left for you.
Repeat Dialling <Outside Call>
DC LND
(Hear Busy Tone Repeat Dial Key
or No answer)
(SC.851+29)
[Flashes red when set.]
[Press flashing key to cancel.]
u The system periodically redials the call. Repeat duration is programmable. Ask your NEC Authorised
Supplier for details.
u You should lift the handset when the called party answered.
u You can cancel this function by pressing " DC" and " LND" during idle condition.
u Does not reserve line. Will select other available line when original line is in use.
VOL
4 1
(Check Name)
Extension Number
SPK
? ? ?
SPK
7

Placing Calls

Placing an Outside Call <Quick Access>
Telephone Number
Trunk Key
? ? ? ?
u Listen for Dial Tone before dialling a Telephone Number.
u You can have function keys for Trunks or Trunk Groups. Ask your Supplier.
Placing an Outside Call <Access Code>
CALL Trunk Code Telephone Number
? ?
9
u Listen for Dial Tone before dialling the Telephone Number.
Placing an Intercom Call <Dial Access>
Extension Number
CALL
? ? ?
u Pressing CALL key after dialling an extension number is also possible.
u Your call will ring or voice-announce. If you hear ringing, wait for an answer. If you hear a beep, begin
speaking. Dialling " 1" changes voice/ring mode (where the destination is an XN120 Telephone).
? ?
4