Placing Calls - NEC DT510 User Manual

Voice Announce Calls
(1) Adjust the Speaker volume as needed.
Note: On SV9100 if MIC key is not lit the
user cannot answer voice announce calls
without lifting the handset.
(2) Respond hands free.
Note: The handset may be used any time
during the conversation.
Camp-on (Call Waiting)
Receive the camp-on tone while on another call:
(1) When a Camp On is set from another station,
complete the present call and a Call Back will ring
the station that set the Camp On.
(2) When the Camp On station answers and rings
the phone, lift the handset or press the Speaker
key.
Off Hook Signaling
With a call in progress:
(1) Receive Off-Hook signaling.
(2) Press the Answer key, then converse with the
second party.
2-11 MON 10:56AM
TALKING TO
Conf
Note: The second call may be placed on Hold.
Note: Press the flashing Line key or Conf key to return
to the first call.
UP
DOWN
STA 12345

Placing Calls

Internal Calls
(1) Lift the handset.
(2) Dial a station number or 0 (for attendant).
(3) Voice announce after the tone burst, or wait for
the ringing call to be answered.
Outside Calls
(1) Lift the handset.
(2) Dial the trunk access code (i.e. 9).
-OR-
(1) Press an idle Programmable Outside Line key.
(2) Dial the telephone number.
(3) Converse.
Line 001
Conf
Trunk Queuing
After pressing a busy Line key and receiving the trunk
busy indication:
(1) Dial # or press Trunk Queuing/Camp On key
(Service Code 751:35).
(2) Replace the handset.
Note: When a line is available, your telephone will
ring; lift the handset and place the call.
10
00:15
2142622000
Rpt Save Trf