Host Name; Usb Storage - ZyXEL Communications ZyWall USG20-VPN User Manual

• Use the System > ZON screen (see
One Network (ZON) utility that uses ZyXEL Discovery Protocol (ZDP) for discovering and
configuring ZDP-aware ZyXEL devices in the same network as the computer on which ZON is
installed.
Note: See each section for related background information and term definitions.

30.2 Host Name

A host name is the unique name by which a device is known on a network. Click Configuration >
System > Host Name to open the Host Name screen.
Figure 367 Configuration > System > Host Name
The following table describes the labels in this screen.
Table 229 Configuration > System > Host Name
LABEL
System Name
Domain Name
Apply
Reset

30.3 USB Storage

The USG can use a connected USB device to store the system log and other diagnostic information.
Use this screen to turn on this feature and set a disk full warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and
use the FAT16, FAT32, EXT2, or EXT3 file system.
Click Configuration > System > USB Storage to open the screen as shown next.
Chapter 30 System
Section 30.16 on page
DESCRIPTION
Enter a descriptive name to identify your USG device. This name can be up to 64
alphanumeric characters long. Spaces are not allowed, but dashes (-) underscores (_) and
periods (.) are accepted.
Enter the domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled. This name can be up to 254
alphanumeric characters long. Spaces are not allowed, but dashes "-" are accepted.
Click Apply to save your changes back to the USG.
Click Reset to return the screen to its last-saved settings.
USG20(W)-VPN Series User's Guide
587) to enable or disable the ZyXEL
539