ZyXEL Communications ZyWall USG20-VPN User Manual page 489

Figure 328 Configuration > Object > Address > Address
The following table describes the labels in this screen. See
information as well.
Table 199 Configuration > Object > Address > Address
LABEL
IPv4 Address Configuration
Add
Edit
Remove
Object
References
#
Name
Type
IPv4 Address
Reference
29.5.2.1 IPv4 Address Add/Edit Screen
The Configuration > IPv4 Address Add/Edit screen allows you to create a new address or edit
an existing one. To access this screen, go to the Address screen (see
and click either the Add icon or an Edit icon in the IPv4 Address Configuration section.
Figure 329 IPv4 Address Configuration > Add/Edit
Chapter 29 Object
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to be able to modify the entry's settings.
To remove an entry, select it and click Remove. The USG confirms you want to remove it
before doing so.
Select an entry and click Object References to open a screen that shows which settings
use the entry.
This field is a sequential value, and it is not associated with a specific address.
This field displays the configured name of each address object.
This field displays the type of each address object. "INTERFACE" means the object uses
the settings of one of the USG's interfaces.
This field displays the IPv4 addresses represented by each address object. If the object's
settings are based on one of the USG's interfaces, the name of the interface displays first
followed by the object's current address settings.
This displays the number of times an object reference is used in a profile.
USG20(W)-VPN Series User's Guide
489
Section 29.5.2.1 on page 489
Section 29.5.2 on page
for more
488),