ZyXEL Communications ZyWall USG20-VPN User Manual page 324

Table 126 Configuration > Security Policy > Policy Control (continued)
LABEL DESCRIPTION
IPv4 / IPv6 Type an IPv4 or IPv6 IP address to view all security policies based on the IPv4 / IPv6
Destination
destination address object used.
• An IPv4 IP address is written as four integer blocks separated by periods. This is an
example IPv4 address: 172.16.6.7.
• An 128-bit IPv6 address is written as eight 16-bit hexadecimal blocks separated by
colons (:). This is an example IPv6 address:
2001:0db8:1a2b:0015:0000:0000:1a2f:0000.
Service View all security policies based the service object used.
User View all security policies based on user or user group object used.
Schedule View all security policies based on the schedule object used.
General Settings Enable or disable the Security Policy feature on the USG.
Enable Policy Select this to activate Security Policy on the USG to perform access control.
Control
IPv4/IPv6 Policy Use the following items to manage IPv4 and IPv6 policies.
Management
Allow If an alternate gateway on the LAN has an IP address in the same subnet as the USG's LAN
Asymmetrica
IP address, return traffic may not go through the USG. This is called an asymmetrical or
l Route
"triangle" route. This causes the USG to reset the connection, as the connection has not
been acknowledged.
Select this check box to have the USG permit the use of asymmetrical route topology on
the network (not reset the connection).
Note: Allowing asymmetrical routes may let traffic from the WAN go directly to the LAN
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry's settings.
Remove To remove an entry, select it and click Remove. The USG confirms you want to remove it
before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Move To change a policy's position in the numbered list, select the policy and click Move to
display a field to type a number for where you want to put that policy and press [ENTER] to
move the policy to the number that you typed.
The ordering of your policies is important as they are applied in order of their numbering.
Clone Use Clone to create a new entry by modifying an existing one.
• Select an existing entry.
• Click Clone, type a number where the new entry should go and then press [ENTER].
• A configuration copy of the selected entry pops up. You must at least change the name
as duplicate entry names are not allowed.
The following read-only fields summarize the policies you have created that apply to traffic traveling in the
selected packet direction.
Priority This is the position of your Security Policy in the global policy list (including all through-
USG and to-USG policies). The ordering of your policies is important as policies are applied
in sequence. Default displays for the default Security Policy behavior that the USG
performs on traffic that does not match any other Security Policy.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
Chapter 20 Security Policy
without passing through the USG. A better solution is to use virtual interfaces to put
the USG and the backup gateway on separate subnets.
USG20(W)-VPN Series User's Guide
324