ZyXEL Communications ZyWall USG20-VPN User Manual page 201

Table 76 Configuration > Network > Interface > VLAN > Add / Edit (continued)
LABEL DESCRIPTION
Enable IP/MAC Select this option to have the USG enforce links between specific IP addresses and
Binding
specific MAC addresses for this VLAN. This stops anyone else from manually using a
bound IP address on another device connected to this interface. Use this to make use
only the intended users get to use specific IP addresses.
Enable Logs for Select this option to have the USG generate a log if a device connected to this VLAN
IP/MAC Binding
attempts to use an IP address that is bound to another device's MAC address.
Violation
Static DHCP Configure a list of static IP addresses the USG assigns to computers connected to the
Table
interface. Otherwise, the USG assigns an IP address dynamically using the interface's
IP Pool Start Address and Pool Size.
Add Click this to create a new entry.
Edit Select an entry and click this to be able to modify it.
Remove Select an entry and click this to delete it.
# This field is a sequential value, and it is not associated with a specific entry.
IP Address Enter the IP address to assign to a device with this entry's MAC address.
MAC Address Enter the MAC address to which to assign this entry's IP address.
Description Enter a description to help identify this static DHCP entry. You can use alphanumeric
and ()+/:=?!*#@$_%- characters, and it can be up to 60 characters long.
RIP Setting See
Enable RIP Select this to enable RIP on this interface.
Direction This field is effective when RIP is enabled. Select the RIP direction from the drop-down
list box.
BiDir - This interface sends and receives routing information.
In-Only - This interface receives routing information.
Out-Only - This interface sends routing information.
Send Version This field is effective when RIP is enabled. Select the RIP version(s) used for sending
RIP packets. Choices are 1, 2, and 1 and 2.
Receive Version This field is effective when RIP is enabled. Select the RIP version(s) used for receiving
RIP packets. Choices are 1, 2, and 1 and 2.
V2-Broadcast This field is effective when RIP is enabled. Select this to send RIP-2 packets using
subnet broadcasting; otherwise, the USG uses multicasting.
OSPF Setting See
Area Select the area in which this interface belongs. Select None to disable OSPF in this
interface.
Priority Enter the priority (between 0 and 255) of this interface when the area is looking for a
Designated Router (DR) or Backup Designated Router (BDR). The highest-priority
interface identifies the DR, and the second-highest-priority interface identifies the BDR.
Set the priority to zero if the interface can not be the DR or BDR.
Link Cost Enter the cost (between 1 and 65,535) to route packets through this interface.
Passive Select this to stop forwarding OSPF routing information from the selected interface. As
Interface
a result, this interface only receives routing information.
Chapter 9 Interfaces
Section 10.6 on page 239
Section 10.7 on page 241
USG20(W)-VPN Series User's Guide
201
for more information about RIP.
for more information about OSPF.