ZyXEL Communications ZyWall USG20-VPN User Manual page 531

The following table describes the labels in this screen.
Table 226 Configuration > Object > ISP Account > Edit
LABEL DESCRIPTION
Profile Name This field is read-only if you are editing an existing account. Type in the profile name of the
ISP account. The profile name is used to refer to the ISP account. You may use 1-31
alphanumeric characters, underscores(
a number. This value is case-sensitive.
Protocol This field is read-only if you are editing an existing account. Select the protocol used by
the ISP account. Options are:
pppoe - This ISP account uses the PPPoE protocol.
pptp - This ISP account uses the PPTP protocol.
Authentication Use the drop-down list box to select an authentication protocol for outgoing calls. Options
Type are:
CHAP/PAP - Your USG accepts either CHAP or PAP when requested by this remote node.
Chap - Your USG accepts CHAP only.
PAP - Your USG accepts PAP only.
MSCHAP - Your USG accepts MSCHAP only.
MSCHAP-V2 - Your USG accepts MSCHAP-V2 only.
Encryption This field is available if this ISP account uses the PPTP protocol. Use the drop-down list
Method box to select the type of Microsoft Point-to-Point Encryption (MPPE). Options are:
nomppe - This ISP account does not use MPPE.
mppe-40 - This ISP account uses 40-bit MPPE.
mppe-128 - This ISP account uses 128-bit MMPE.
User Name Type the user name given to you by your ISP.
Password Type the password associated with the user name above. The password can only consist of
alphanumeric characters (A-Z, a-z, 0-9). This field can be blank.
Retype to Type your password again to make sure that you have entered is correctly.
Confirm
Server IP If this ISP account uses the PPPoE protocol, this field is not displayed.
If this ISP account uses the PPTP protocol, type the IP address of the PPTP server.
Connection ID This field is available if this ISP account uses the PPTP protocol. Type your identification
name for the PPTP server. This field can be blank.
Service Name If this ISP account uses the PPPoE protocol, type the PPPoE service name to access. PPPoE
uses the specified service name to identify and reach the PPPoE server. This field can be
blank.
If this ISP account uses the PPTP protocol, this field is not displayed.
Compression Select On button to turn on stac compression, and select Off to turn off stac compression.
Stac compression is a data compression technique capable of compressing data by a factor
of about four.
Idle Timeout This value specifies the number of seconds that must elapse without outbound traffic
before the USG automatically disconnects from the PPPoE/PPTP server. This value must be
an integer between 0 and 360. If this value is zero, this timeout is disabled.
OK Click OK to save your changes back to the USG. If there are no errors, the program
returns to the ISP Account screen. If there are errors, a message box explains the error,
and the program stays in the ISP Account Edit screen.
Cancel Click Cancel to return to the ISP Account screen without creating the profile (if it is new)
or saving any changes to the profile (if it already exists).
Chapter 29 Object
USG20(W)-VPN Series User's Guide
531
), or dashes (-), but the first character cannot be
_