Secured Service Status Screen - ZyXEL Communications ZyWall USG20-VPN User Manual

This table describes the fields in the above screen.
Table 27 Dashboard > Interface Status Summary
LABEL
Name
Status
Zone
IP Addr/Netmask
IP Assignment
Action

5.2.12 Secured Service Status Screen

This part shows what security services are available and enabled.
Chapter 5 Dashboard
DESCRIPTION
This field displays the name of each interface.
This field displays the current status of each interface. The possible values depend on
what type of interface it is.
For Ethernet interfaces:
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface does not have any physical ports associated with it or
the Ethernet interface is enabled but not connected.
Speed / Duplex - The Ethernet interface is enabled and connected. This field displays
the port speed and duplex setting (Full or Half).
For cellular (mobile broadband) interfaces, see
that can appear.
For the auxiliary interface:
Inactive - The auxiliary interface is disabled.
Connected - The auxiliary interface is enabled and connected.
Disconnected - The auxiliary interface is not connected.
For PPP interfaces:
Connected - The PPP interface is connected.
Disconnected - The PPP interface is not connected.
If the PPP interface is disabled, it does not appear in the list.
For WLAN interfaces:
Up - The WLAN interface is enabled.
Down - The WLAN interface is disabled.
This field displays the zone to which the interface is currently assigned.
This field displays the current IP address and subnet mask assigned to the interface. If
the IP address is 0.0.0.0/0.0.0.0, the interface is disabled or did not receive an IP
address and subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays the IP
address it is currently using. This is either the static IP address of the interface (if it is
the master) or the management IP address (if it is a backup).
This field displays the interface's IP assignment. It will show DHCP or Static.
Use this field to get or to update the IP address for the interface.
Click Renew to send a new DHCP request to a DHCP server.
Click the Connect icon to have the USG try to connect a PPPoE/PPTP interface. If the
interface cannot use one of these ways to get or to update its IP address, this field
displays n/a.
Click the Disconnect icon to stop a PPPoE/PPTP connection.
USG20(W)-VPN Series User's Guide
95
Section 6.10 on page 113 for the status