Internet Access - Device Registration - ZyXEL Communications ZyWall USG20-VPN User Manual

SSID Setting
• SSID - Enter a descriptive name of up to 32 printable characters for the wireless LAN.
• Security Mode - Select Pre-Shared Key to add security on this wireless network. Otherwise,
select None to allow any wireless client to associate this network without authentication.
• Pre-Shared Key - Enter a pre-shared key of between 8 and 63 case-sensitive ASCII characters
(including spaces and symbols) or 64 hexadecimal characters.
• Hidden SSID - Select this option if you want to hide the SSID in the outgoing beacon frame. A
wireless client then cannot obtain the SSID through scanning using a site survey tool.
• Enable Intra-BSS Traffic Blocking - Select this option if you want to prevent crossover traffic
from within the same SSID. Wireless clients can still access the wired network but cannot
communicate with each other.
For Built-in Wireless AP Only
• Bridged to: USGs with W in the model name have a built-in AP. Select an interface to bridge
with the built-in AP wireless network. Devices connected to this interface will then be in the same
broadcast domain as devices in the AP wireless network.

2.1.8 Internet Access - Device Registration

Click the link in this screen to register your device at portal.myzyxel.com.
Note: The USG must be connected to the Internet in order to register.
Figure 30 Internet Access: Device Registration
You will need the USG's serial number and LAN MAC address to register it if you have not already
done so. Use the Configuration > Licensing > Registration > Service screen to update your
service subscription status.
Chapter 2 Installation Setup Wizard
USG20(W)-VPN Series User's Guide
44