Creating A Data Link For Dmx And Synchronized Operation - Martin Mania EFX500 User Manual

4. Hold the fixture up to the surface so that the screwbolt heads pass
through the centers of the keyholes A in the mounting plate, and slide
the fixture to engage the screwbolt heads in the mounting plate.
5. Using one of the remaining holes in the mounting plate as a guide,
mark a position for a fourth hole to accept a screwbolt that will lock the
fixture in place.
6. Remove the fixture from the surface, drill the fourth hole and replace
the fixture on the surface as described in point 4 above. Screw the
fourth screwbolt through the mounting plate into the surface to lock the
fixture in place, using a washer on the screwbolt if necessary.
7. Install an eyebolt and safety attachment once the fixture is mounted.
Overhead mounting
To hang the Mania EFX on an overhead structure:
1. If using a rigging clamp, ensure that the clamp is undamaged and can
bear at least 10 times the fixture's weight. Bolt the clamp securely to
the fixture's mounting plate with a grade 8.8 (minimum) M12 bolt and
lock nut through one of the 13 mm holes provided, or as recommended
by the clamp manufacturer. The clamp must be attached centrally in
the mounting plate to distribute the load evenly.
2. Working from a stable
platform, clamp or fasten the
fixture to the structure.
3. Install a safety cable that can
hold at least 10 times the
weight of the fixture.
4. Loosen the swivel locks, tilt
the fixture to the desired
angle, and retighten.
Important! Check to make sure that the mirror drum cable does not rub
on the mounting plate. If it does, reverse the mounting plate
(see illustration).
C r e a t i n g a d a t a l i n k f o r D M X a n d
s y n c h r o n i z e d o p e r a t i o n
You need a serial data link to:
• run light shows on one or more fixtures using a DMX controller, or
• run synchronized light shows on two or more fixtures (master/slave
operation).
Installation 11