Martin Mania EFX500 User Manual page 10

Surface mounting
To mount the Mania EFX500/600 on a
surface, you will need four grade 8.8
(minimum) 8mm diameter, 13mm head hex
screwbolts (or similar type fasteners of the
same grade and size) and an eyebolt for the
safety cable.
I n s t a l l i n g t h e m o u n t i n g p l a t e
s e p a r a t e l y
Surface mounting is easiest if you detach
the mounting plate from the fixture, bolt the
mounting plate to the surface, and then reattach the fixture. If you choose
this method, access for reattachment and adjustment can be easier if you
remove the swivel locks and replace them with two M8 hexagonal lock
nuts, P/N 08132701. Install an eyebolt and safety attachment once the
fixture is mounted.
I n s t a l l i n g t h e f i x t u r e a n d m o u n t i n g p l a t e a s a u n i t
If you prefer to install the fixture and mounting plate without separating
them:
1. Using the inside back cover of this manual as a guide, drill three holes
in the positions marked A.
2. Screw three grade
8.8 (minimum)
8mm diameter,
13mm head hex
screwbolts or bolts
into the holes at A,
but do not tighten
them fully –allow
enough clearance
between the bolt
head and surface
for the 3mm thick
mounting plate.
3. Fold the mounting
plate so that it lies flat against the back of the fixture and tighten the
swivel locks. For easier access for adjustment, it is possible to remove
the swivel locks and replace them with two M8 hexagonal lock nuts,
P/N 08132701).
10
Ø8mm
Mania EFX500 & EFX600 user manual
A
A