Table of Contents
Advertisement
SITE SETTING [ADD]
(This is not available in SAMS Pro Lite.)
1.
From the upper menu, select [System Management] > [Site Setting].
2.
Click Add <
> in the tool bar.
J
If a site has been newly added, Site Setting of SAMS Communication Server Pro should be done again.
3.
Enter the [Site].
4.
Enter the IP address of the computer that is installed with SAMS Communication Server Pro.
5.
Check the port. It is recommended to use the default 51008.
J
If this port is changed, communication to the SAMS Communication Server Pro may not establish. If changed this
port, make the same change to the SAMS Communication Server Pro too.
6.
Check whether the [Use] is checked.
J
If [Use] is not checked, communication to the corresponding communication server will not establish. This can be
used when intended not to connect temporarily to a specifi c server.
7.
By using the [Connection Test], check if SAMS Pro properly connects to the SAMS Communication Server Pro.
8.
Click Save <
> in the tool bar.
English Englis_
English _65
Advertisement
Table of Contents
