JOYTECH PY800AC User Manual page 16

PY800AC/PY1400AC SLIDING GATE OPERATOR
� � � �
Disconnect from mains supply before replacing bulb.
� � � �
Be sure to read the entire manual before attempting to perform any
installation or service to the door operator.
� � � �
Our company reserves the right to change the design and specification
without prior notification.
10. 10. Troubleshooting Troubleshooting
10. 10. Troubleshooting Troubleshooting
Trouble
The door fails to
open and close.
LED display does
not light.
The door can
open, fails
close.
Remote
transmitter does
not work.
The transmitter
operating distance
is too short.
11. Packing list
11. 11. 11. Packing Packing Packing list list list
After receiving the gate operator, you should make an unpack-inspection,
in which you should check whether the product was damaged. If you have
any problem please contact our dealer. You should find the following
items in our standard packing:
Possible causes
1. Power is OFF
2. Fuse burn
1. Infrared
obstructed.
2.Infrared
to
function is enable, but the
photocell has not been
installed.
1. Battery level may be
low
2. Transmitter code is lost
Battery level may be low.
1.Make
power is ON.
2. Replace fuse.
beam is 1.Remove
obstructions.
photocell 2.Make
infrared
function is disable.
1. Replace the battery
inside the transmitter.
2.Re-program
transmitter.
Replace battery.
15
Solutions
sure that
sure the
photocell
the