Disposal - Hilti SF 8H-A22 Operating Instructions Manual

Fault
No hammering
action.
en
The on / off switch
can't be pressed,
i.e. the switch is
locked.
The battery runs
down more
quickly than usual.
The battery does-
n't engage with
an audible double
click.
The power tool or
the battery gets
very warm.

10 Disposal

CAUTION
Improper disposal of the equipment may have serious con-
sequences: the burning of plastic components generates toxic
fumes which may present a health hazard. Batteries may ex-
plode if damaged or exposed to very high temperatures, causing
poisoning, burns, acid burns or environmental pollution. Careless
disposal may permit unauthorized and improper use of the equip-
ment. This may result in serious personal injury, injury to third
parties and pollution of the environment.
CAUTION
Dispose of defective batteries without delay. Keep them out of
reach of children. Do not attempt to open or dismantle batteries
and do not dispose of them by incineration.
CAUTION
Dispose of the batteries in accordance with national regulations or
return them to Hilti.
Most of the materials from which Hilti power tools or appliances
are manufactured can be recycled. The materials must be correctly
separated before they can be recycled. In many countries, Hilti
has already made arrangements for taking back your old power
tools or appliances for recycling. Please ask your Hilti customer
service department or Hilti representative for further information.
30
Printed: 14.11.2013 | Doc-Nr: PUB / 5161651 / 000 / 00
Possible cause
The torque and op-
erating mode setting
ring are not set to the
hammer drilling sym-
bol.
The forward / re-
verse switch is in
the middle position
(transport lock en-
gaged).
Battery condition is
not optimal.
The retaining lugs on
the battery are dirty.
Electrical fault.
The power tool has
been overloaded (ap-
plication limits ex-
ceeded).
Remedy
Turn the torque and
operating mode set-
ting ring to the ham-
mer drilling symbol.
Push the forward /
reverse switch to the
left or right.
Have battery con-
dition diagnosed by
Hilti Service or re-
place with a new bat-
tery.
Clean the retaining
lugs and check that
the battery engages
securely. Contact Hilti
Service if the problem
persists.
Switch the power tool
off immediately, re-
move the battery and
contact Hilti Service.
Use the right power
tool for the job (don't
use a low-powered
tool for heavy work).