Troubleshooting; Disposal - Hilti SR16 Operating Instructions Manual

10. Troubleshooting

Fault
The tool doesn't start.
en
The tool does not
achieve full power.
The drill bit makes no
progress.

11. Disposal

Most of the materials from which Hilti electric tools are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old electric tools for recycling. Please ask your Hilti customer service department or Hilti rep-
resentative for further information.
Should you wish to return the electric tool yourself to a disposal facility for recycling, proceed as follows: Dis-
mantle the electric tool as far as possible without the need for special tools. Use absorbent paper to wipe oily
parts clean and to collect any grease that runs out. This paper should also be disposed of correctly. On no
account should grease be allowed to enter the waste water system or to find its way into the ground.
The individual parts should be separated as follows:
Part/assembly
Toolbox
Gear housing
Bearing plate
Grip, side handle
Motor housing
Fan
Motor (rotor and stator)
Supply cord
Gearing parts
Screws, small parts
8
Printed: 07.07.2013 | Doc-Nr: PUB / 5070702 / 000 / 00
Possible cause
Fault in mains supply
Supply cord or plug defective
Speed control switch defective
The extension cord is too long or has
inadequate cross section
Speed control switch not fully
pressed
The forward/reverse button is set to
reverse rotation.
Part/assembly
Plastic
Plastic
Plastic
Plastic
Plastic
Plastic
Steel and copper
Copper, synthetic rubber
Steel
Steel
Remedy
Plug in another electric appliance and
check whether it works.
Have the cord checked and, if neces-
sary, replaced by an electrical specialist.
Have it checked and, if necessary,
replaced by an electrical specialist.
Use a shorter extension cord or a cord
with adequate cross section.
Press the speed control switch as far
as it will go.
Set the button to forward rotation.
Part/assembly
Plastics recycling
Plastics recycling
Plastics recycling
Plastics recycling
Plastics recycling
Plastics recycling
Scrap metal
Scrap metal
Scrap metal
Scrap metal