CHECKING THE CONNECTIONS
Check the leads couplers and connectors for
,
stains rust moisture etc
,
,
,
1.
Disconnect
:
• Lead
• Coupler
• Connector
2.
Check
:
• Lead
• Coupler
• Connector
Moisture Dry with an air blower
→
Rust stains
/
→
Connect and disconnect several
times
.
3. Check:
• All connections
Loose connection Connect properly.
→
NOTE:
If the pin "1" on the terminal is flattened, bend it up.
4. Connect:
• Lead
• Coupler
• Connector
NOTE:
Make sure all connections are tight.
5. Check:
• Continuity
(with the multimeter)
,
.
.
CHECKING THE CONNECTIONS
NOTE:
• If there is no continuity, clean the terminals.
• When checking the wire harness, perform
steps (1) to (3).
• As a quick remedy, use a contact revitalizer
available at most part stores.
1-7