IMPORTANT INFORMATION
BEARINGS AND OIL SEALS
Install bearings and oil seals so that the
manufacturer's marks or numbers are visible.
When installing oil seals "1", lubricate the oil seal
lips with a light coat of lithium-soap-based
grease. Oil bearings liberally when installing, if
appropriate.
CAUTION :
Do not spin the bearing with compressed air
because this will damage the bearing
surfaces.
CIRCLIPS
Before reassembly, check all circlips carefully
and replace damaged or distorted circlips.
Always replace piston pin clips after one use.
When installing a circlip "1", make sure the sharp-
edged corner "2" is positioned opposite the thrust
"3" that the circlip receives.
1-6