REMOVING THE FRONT WHEEL
1. Stand the vehicle on a level surface.
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Elevate:
Front wheel
l
NOTE:
Place the vehicle on a suitable stand so that the
front wheel is elevated.
3. Remove:
Front wheel
l
Speed sensor unit
l
Collar
l
NOTE:
Do not squeeze the brake lever when removing
the front wheel.
DISASSEMBLING THE FRONT WHEEL
1. Remove:
Oil seal
l
Wheel bearings
l
s s s s s s s s s s s s s s s s s s s s s s s s s s s s s s s s s s s s s
a. Clean the outside of the front wheel hub.
b. Remove the oil seal "1" with a flat-head
screwdriver.
NOTE:
To prevent damaging the wheel, place a rag "2"
between the screwdriver and the wheel surface.
c. Remove the wheel bearings with a bearing
puller.
sssssssssssssssssssssssssssssssssssss
CHECKING THE FRONT WHEEL
1. Check:
Wheel axle
l
Roll the wheel axle on a flat surface.
Bends → Replace.
WARNING
Do not attempt to straighten a bent wheel ax-
le.
2. Check:
Tyre
l
Front wheel
l
Damage/wear → Replace.
Refer to "CHECKING THE TYRES" on page
3-22 and "CHECKING THE WHEELS" on
page 3-23.
3. Measure:
Radial wheel runout"1"
l
Lateral wheel runout"2"
l
Over the specified limits → Replace.
Radial wheel runout limit
1.0 mm
Lateral wheel runout limit
0.5 mm
4-6
FRONT WHEEL