Symbol PDT 8100 Series Product Reference Manual page 127

c. Power up the cradle. Before the power-up LED sequence begins, press a from
the terminal program to load the Cradle Utilities configuration interface. The
following screen appears on the host computer
Cradle Utilities version x.xx
Firmware Datacode xxxxxxxx
1: Public network settings
2: Advanced settings
3: PPP settings
4: Private network settings
5: Firmware Download
Select a submenu OR:
Q: Discard changes and restart
F: Save changes and restart
2. Type 1 to display the Public network settings menu
Public network settings
1: Static Mode: 0
2: NAPT Mode: 1
The following settings are only used when Static
mode is 1
3: Cradle IP Address: 0.0.0.0
4: Router (Gateway) IP Address: 0.0.0.0
5: 1st DNS IP Address 0.0.0.0
6: 2nd DNS IP Address 0.0.0.0
7: 1st WINS IP Address 0.0.0.0
8: 2nd WINS IP Address 0.0.0.0
9: Subnet Mask: 0.0.0.0
The following settings are only used when NAPT mode
is 0 and Static mode is 1
A: Terminal 1 IP Address 0.0.0.0
B: Terminal 2 IP Address 0.0.0.0
C: Terminal 3 IP Address 0.0.0.0
D: Terminal 4 IP Address 0.0.0.0
E:Expansion Port IP Address: 0.0.0.0
3. At the Public network settings menu:
a. Press 1 and set Static Mode to 1.
b. Press 2 and set the NAPT Mode to 0.
c. Press 3, and set the cradle IP address.
d. Press 4 and set the Router IP address to the IP address of your internet
gateway.
e. Use options 5 and 6 to set the DNS IP (server) addresses.
f. Use options 7 and 8 to set the WINS IP (server) addresses. This is required for
ActiveSync to function properly.
g. Press 9 and set the correct subnet mask for your subnet.
h. Press A, B, C, D, and E to set the 4 slot and expansion port IP addresses.
Communications
:
:
4-25