Installing Econnect - Symbol PDT 8100 Series Product Reference Manual

Note: You must perform the first ActiveSync operation with a local, direct
connection.
To retain partnerships after a hard reset, capture partnership registry
information in a .reg file and save it in the Flash File System. See the
Windows CE Software Developer's Kit for Symbol Terminals (Help
File) included in the SDK for details.
(The Symbol Software Developer's Kit (SDK for the PDT 8100
Series with Intel XScale Technology is available at
http://devzone.symbol.com/.)
For more information about using ActiveSync, start ActiveSync on the host computer, then
see ActiveSync Help.

Installing eConnect

eConnect is a control panel applet you may install on a terminal; it automates connection
via modem or 4-slot cradle, and the launch of applications such as ActiveSync or Internet
Explorer.
Note: eConnect is used only when establishing a modem connection, or
with the 4-Slot Ethernet cradle.
Download eConnect (for PDT 8100) from http://devzone.symbol.com. Follow the
instructions included with the software to install and configure eConnect on the terminal.
Ensure that you download the appropriate version for your operating system.
Note: When configuring eConnect for use with a 4-slot ethernet cradle,
verify that the Connect Using selection is set to 115200 Default. This
is the serial baud rate between the PDT 8100 COM port and the
cradle slot.
Communications
4-5