Aligning The Screen - Symbol PDT 8100 Series Product Reference Manual

As the terminal initializes its Flash File System, the Symbol Splash screen displays for
about 30 seconds. When the Welcome screen appears, tap anywhere on the screen to
continue to the Align screen. Note that these screens also appear every time a hard reset
(cold boot) is performed.

Aligning the Screen

To align the terminal so the cursor on the touch screen aligns with the tip of the stylus:
1. If necessary, adjust the backlight on the terminal so the screen is readable. See
Adjusting the Backlight
2. Remove the stylus from its storage silo on the back of the terminal.
3. Tap the center of each target that appears on the screen with the tip of the stylus.
Note: To align the screen at anytime, press the Function key and Trigger
key simultaneously to launch the calibration screen.
on page 2-4.
Figure 1-20. Tapping the Target
Getting Started
1-29