Chapter 2
Measurement & Automation Explorer
Windows 2000/NT
Access Additional Help and Resources
NI-488.2 Online Help
NI-488.2 User Manual for Windows
3.
Expand the Devices and Interfaces directory by clicking on the + next
to the folder.
4.
Click on your GPIB interface and select Tools»Settings»NI-488.2
from the Explorer menu.
5.
Enable or disable DOS support in the NI-488.2 Settings dialog box
and click on the OK button.
6.
If you are prompted to do so, restart your system.
To enable NI-488.2 DOS support in Windows 2000/NT, complete the
following steps:
1.
Open your
config.nt
directory (for example,
2.
Find the following lines:
REM ***To run DOS GPIB applications, uncomment the
REM ***following line
REM device=<path>\doswin16\gpib-nt.com
where
is the directory in which you installed the NI-488.2
<path>
software.
3.
Remove
from the last line so that it reads as follows:
REM
device=<path>\doswin16\gpib-nt.com
To disable DOS support, add
To access additional help and resources for the NI-488.2 software and your
GPIB hardware, refer to the following sections.
The NI-488.2 for Windows Online Help addresses questions you might
have about NI-488.2, includes troubleshooting information, and describes
the NI-488.2 API. You can access the NI-488.2 online help as follows:
1.
Select Start»Programs»National Instruments NI-488.2»Explore
GPIB to start Measurement & Automation Explorer.
2.
Expand the Devices and Interfaces directory by clicking on the + next
to the folder.
file, located in the Windows NT system32
c:\windows\system32
back to the line where it was removed.
REM
2-14
).
www.natinst.com