National Instruments NI-488.2 User Manual page 87

GPIB Basics
Talkers, Listeners, and Controllers
Controller-In-Charge and System Controller
© National Instruments Corporation
The ANSI/IEEE Standard 488.1-1987, also known as General Purpose
Interface Bus (GPIB), describes a standard interface for communication
between instruments and controllers from various vendors. It contains
information about electrical, mechanical, and functional specifications.
GPIB is a digital, 8-bit parallel communications interface with data transfer
rates of 1 Mbyte/s and higher, using a three-wire handshake. The bus
supports one System Controller, usually a computer, and up to 14 additional
instruments. The ANSI/IEEE Standard 488.2-1992 extends IEEE 488.1 by
defining a bus communication protocol, a common set of data codes and
formats, and a generic set of common device commands.
GPIB devices can be Talkers, Listeners, or Controllers. A Talker sends out
data messages. Listeners receive data messages. The Controller, usually a
computer, manages the flow of information on the bus. It defines the
communication links and sends GPIB commands to devices.
Some devices are capable of playing more than one role. A digital
voltmeter, for example, can be a Talker and a Listener. If your system has a
National Instruments GPIB interface and software installed, it can function
as a Talker, Listener, and Controller.
You can have multiple Controllers on the GPIB, but only one Controller at
a time can be the active Controller, or Controller-In-Charge (CIC). The CIC
can be either active or inactive (standby). Control can pass from the current
CIC to an idle Controller, but only the System Controller, usually a GPIB
interface, can make itself the CIC.
A-1
A
NI-488.2 User Manual for Windows