National Instruments Measure Data Acquisition User Manual page 70

underWriteErr
-10844
overFlowErr
-10845
overWriteErr
-10846
dmaChainingErr
-10847
noDMACountAvailErr
-10848
OpenFileError
-10849
closeFileErr
-10850
fileSeekErr
-10851
readFileErr
-10852
writeFileErr
-10853
miscFileErr
-10854
osUnsupportedError
-10855
osError
-10856
New data was not written to the output
transfer buffer before the driver
attempted to transfer data to the
device.
Because of system limitations, the
driver could not read data from the
device fast enough to keep up with the
device throughput. The onboard
device memory reported an overflow
error.
The driver wrote new data into the
input transfer buffer before the
previously acquired data was read.
New buffer information was not
available at the time of the DMA
chaining interrupt; DMA transfers will
terminate at the end of the currently
active transfer buffer.
The driver could not obtain a valid
reading from the transfer-count
register in the DMA controller.
The configuration file or DSP kernel
file could not be opened.
Unable to close a file.
Unable to seek within a file.
Unable to read from a file.
Unable to write to a file.
An error occurred accessing a file.
NI-DAQ does not support the current
operation on this particular version of
the operating system.
An unexpected error occurred from the
operating system while performing the
given operation.