National Instruments Measure Data Acquisition User Manual page 55

badCountErr
-10010
badIntervalErr
-10011
badRangeErr
-10012
badErrorCodeErr
-10013
groupTooLargeErr
-10014
badTimeLimitErr
-10015
badReadCountErr
-10016
badReadModeErr
-10017
badReadOffsetErr
-10018
badClkFrequencyErr
-10019
badTimebaseErr
-10020
badLimitsErr
-10021
badWriteCountErr
-10022
badWriteModeErr
-10023
badWriteOffsetErr
-10024
limitsOutOfRange
-10025
The count is too large or too small for
the specified counter, or the given I/O
transfer count is not appropriate for the
current buffer or channel configuration.
The analog input scan rate is too fast for
the number of channels and the channel
clock rate, or the given clock rate is not
supported by the associated counter
channel or I/O channel.
The analog input or analog output
voltage range is invalid for the specified
channel.
The driver returned an unrecognized or
unlisted error code.
The group size is too large for the device.
The time limit is invalid.
The read count is invalid.
The read mode is invalid.
The offset is unreachable.
The frequency is invalid.
The timebase is invalid.
The limits are beyond the range of the
device.
Possible reasons for this error are as
follows.
Your data array contains incomplete
update.
You are trying to write past the end
of the internal buffer.
Your output operation is continuous
and the length of your array is not a
multiple of one-half the internal
buffer size.
The write mode is out-of-range or is not
allowed.
Adding the write offset to the write mark
places the write mark outside the internal
buffer.
The requested input limits exceed the
device's capability or configuration.
Alternative limits were selected.