National Instruments Measure Data Acquisition User Manual page 66

someInputsIgnoredErr
-10632
invalidRegenModeErr
-10633
noContTransferInProgressE
-10634
rror
invalidSCXIOpModeError
-10635
noContWithSynchError
-10636
bufferAlreadyConfigError
-10637
badChanGainErr
-10680
badChanRangeErr
-10681
badChanPolarityErr
-10682
badChanCouplingErr
-10683
badChanInputModeErr
-10684
clkExceedsBrdsMaxConvRate
-10685
scanListInvalidErr
-10686
bufferInvalidErr
-10687
Certain inputs were ignored because
they were not relevant in the current
operating mode.
The specified analog output
regeneration mode is not allowed for
this device.
No continuous (double buffered)
transfer is in progress for the specified
resource.
Either the SCXI operating mode
specified in a configuration call is
invalid, or a module is in the wrong
operating mode to execute the function
call.
You cannot start a continuous (double-
buffered) operation with a
synchronous function call.
Attempted to configure a buffer after
the buffer had already been
configured. You can configure a buffer
only once.
All channels of this device must have
the same gain.
All channels of this device must have
the same range.
All channels of this device must have
the same polarity.
All channels of this device must have
the same coupling.
All channels of this device must have
the same input mode.
The clock rate exceeded the device's
recommended maximum rate.
A configuration change has invalidated
the scan list.
A configuration change has invalidated
the allocated buffer.