National Instruments Measure Data Acquisition User Manual page 67

noTrigEnabledErr
-10688
digitalTrigBErr
-10689
digitalTrigAandBErr
-10690
extConvRestrictionErr
-10691
chanClockDisabledErr
-10692
extScanClockErr
-10693
unsafeSamplingFreqErr
-10694
DMAnotAllowedErr
-10695
multiRateModeErr
-10696
rateNotSupportedErr
-10697
timebaseConflictErr
-10698
polarityConflictErr
-10699
signalConflictErr
-10700
The number of total scans and
pretrigger scans implies that a
triggered start is intended, but
triggering is not enabled.
Digital trigger B is illegal for the
number of total scans and pretrigger
scans specified.
This device does not allow digital
triggers A and B to be enabled at the
same time.
This device does not allow an external
sample clock with an external scan
clock, start trigger, or stop trigger.
The acquisition cannot be started
because the channel clock is disabled.
You cannot use an external scan clock
when performing a single scan of a
single channel.
The sample frequency exceeds the safe
maximum rate for the hardware, gains,
and filters used.
You have set up an operation that
requires the use of interrupts. DMA is
not allowed.
Multi-rate scanning cannot be used
with the AMUX-64, SCXI, or
pretriggered acquisitions.
Unable to convert your
timebase/interval pair to match the
actual hardware capabilities of this
device.
You cannot use this combination of
scan and sample clock timebases for
this device.
You cannot use this combination of
scan and sample clock source
polarities for this operation and device.
You cannot use this combination of
scan and convert clock signal sources
for this operation and device.